NorCross SONAR H22PX User Manual

USER’S GUIDE  
H22PX – HawkEye® Handheld Sonar System  
Thank you for purchasing a HawkEye® product,  
and welcome to the innovations of NorCross  
Marine Products, Inc. To ensure safety and  
many years of trouble-free operation of your  
product, please read this manual carefully before using this product.  
SAFETY INFORMATION:  
Read this instruction manual carefully before attempting to install or operate this  
device.  
Periodically wipe the case with a dry cloth. Do not use abrasives or solvents on this  
device.  
Only qualified personnel should perform repairs or servicing not covered in this  
manual.  
The LCD used in the product is made of glass. Therefore, it can break when the  
product is dropped or impacted.  
Keep this product away from heat sources such as radiators, heaters, stoves and  
other heat generating sources.  
Do not store in extreme temperatures above 150° F (65° C).  
Shade the LCD during storage. Do not expose LCD to direct sunlight for extended  
periods of time.  
NOTES, NOTICES, AND CAUTIONS  
WARNING: Indicates a potential for property damage, personal injury or death.  
IMPORTANT: Indicates potential damage to the device and tells you how to  
avoid it.  
NOTICE: Indicates important information that helps you make better use of the  
device and tells you how to correct a performance problem.  
INFORMATION: Indicates resources to obtain the proper information to help you  
make the most of your device.  
WARNING:  
This depth sounder should not be used as a navigational aid to  
prevent grounding, boat damage, or personal injury. Always operate  
the boat at slow speeds in unfamiliar water, or if you suspect  
shallow water or submerged objects.  
INFORMATION:  
Read this manual completely before attempting to use or install your  
device. Visit our Customer Service Center on our website for  
advanced troubleshooting and technical support.  
w
w
w
.
h
a
w
k
e
y
e
e
l
e
c
t
r
o
n
i
c
s
.
c
o
m
 
BASIC OPERATION:  
Switching the Readings from English to Metric  
1. Remove the battery holder as per the instructions in the  
“Installing the Batteries” section.  
2. While looking into the battery compartment, use a small  
screwdriver, or other slender object, to reach into the battery  
compartment and move the switch to the LEFT for Metric  
readings, or to the RIGHT for English readings.  
3. Replace the batteries as per the instructions in the “Installing  
the Batteries” section.  
Switch  
Obtaining Depth Readings (Depth Reading Mode)  
1. Place the sonar sensor side of the device into the water.  
Make sure to hold the device perpendicular to the water  
surface.  
2. Press and Release the activation button.  
3. The current water depth will be indicated on the display:  
1 X  
The depth will continue to update 4 times per  
second while the device is left in water that is  
between 2.5 and 200 ft deep (.8 and 61 m).  
If the device is unable to obtain an accurate  
depth reading or if it is removed from the water  
“- - -” will be displayed.  
4. The device will turn off automatically after being removed  
from the water.  
Water Surface  
NOTICE:  
The device will not obtain readings through air. You CANNOT stand  
on the deck of your vessel and obtain readings unless the device is  
in direct contact with the water or you use one of the techniques  
described within this manual.  
Obtaining Fish Readings (Fish Finder Mode)  
1. If a fish is detected while in the Depth Reading Mode, a fish  
icon will illuminate on the display.  
2. A blinking fish icon may represent the presence of a school  
of fish moving though the sonar beam.  
Obtaining Temperature Readings (Thermometer Mode)  
The H22PX has an integrated temperature sensor built into the  
sonar sensor housing.  
To Obtain Temperature Readings:  
Temperature  
Sensor  
1. Activate the Depth Reading Mode.  
2. While in Depth Reading Mode, press and release the  
activation button.”  
3. The display will show the current temperature.  
To obtain air temperature readings, hold the device in your hand and  
activate the Thermometer Mode as per the above instructions.  
To obtain water temperature readings, place the Temperature Sensor  
into the water and activate the Thermometer Mode.  
w
w
w
.
h
a
w
k
e
y
e
e
l
e
c
t
r
o
n
i
c
s
.
c
o
m
 
INFORMATION:  
This device has a temperature accuracy rating of plus or minus 5%. The temperature  
probe may take up to 90 seconds to adjust to extreme changes in  
temperature. If you desire to have instant temperature readings you may  
want to consider purchasing the NorCross® Infrared Marine Thermometer  
(IR101SP).  
SHOOTING THROUGH A BOAT HULL  
The H22PX advanced sonar capabilities allow it to “Shoot-  
1.  
Thru” the bottom of a boat, canoe, kayak, etc.  
The hull must be made out of solid  
fiberglass, or a maximum of 1/8” (3.1 mm)  
aluminum, and be in direct contact with the  
water, with no air pockets.  
The device will not work through wood,  
plastic, or any composite material.  
2
To “Shoot-Thru” the Hull of a Boat, Do One of the  
Following:  
1. Place the transducer in .5 inches (13 mm) of water  
against the hull bottom.  
2. Coat the face of the transducer with petroleum jelly  
and press it against the hull bottom with a twisting  
motion.  
3
3. Place the transducer in a plastic bag that is full of  
water and place against the hull bottom.  
4. Refer to our website for more advanced instructions.  
NOTICE:  
Some boats have a hollow space between the floor and the hull  
bottom called a bilge. The H22PX will not “Shoot-Thru” in this type  
of boat unless it is placed directly against the hull surface that is in  
direct contact with the water.  
SHOOTING THROUGH ICE  
This device has advanced sonar capabilities also allow it to obtain depth and fish reading  
through solid ice. You MUST use special techniques to obtain readings through ice:  
NOTICE:  
The ice must be smooth and free from excessive air.  
Air will show up as white imperfections inside the ice.  
The ice must be black in color.  
w
w
w
.
h
a
w
k
e
y
e
e
l
e
c
t
r
o
n
i
c
s
.
c
o
m
 
To Shoot Thru Ice:  
1. Clear away snow to expose the ice surface.  
2. Place a small amount of liquid water on the ice and set  
the transducer side of the device on the water.  
3. If there are any air pockets between the device and  
ice, or the water below the ice, the device will not work  
properly and will require you to try another spot, or cut  
a hole in the ice to use.  
INFORMATION:  
You can also use the “Plastic Bag” and “Petroleum Jelly” instructions  
in the “Shooting Thru a Boat Hull” section for shooting through ice.  
Visit our website for additional suggestions.  
SCANNING FOR DEPTH CHANGES OR FISH (SIDE-SCAN)  
The device has the ability to be used as a sideways scanning sonar depth  
sounder/fish finder to search for drop-offs and hiding fish under docks,  
weeds, or vegetation.  
To Side-Scan:  
1. Activate the Depth Reading feature.  
2. Place the device perpendicular to the water surface to obtain a  
correct depth reading.  
3. Once a correct reading is obtained, move the H22PX around in a  
scanning motion (similar to using a flashlight).  
NOTICE:  
To obtain depth readings during side scanning the sonar signals  
must be directed at a solid surface that is within 200 ft (61 m) to  
function properly. You must be certain to aim the device at an  
object or the bottom within this range.  
USING FOR DIVING  
The H22PX is waterproof to 200 ft (61 m), allowing you to use it as a  
range finder or target finder for snorkeling or diving. Keep in mind that  
the sonar signals must be directed at a solid surface that is within 200 ft  
(61 m) to display depth readings.  
You must be certain to aim the Device at an object or  
the bottom within this range.  
ALWAYS be certain to attach the Wrist/Safety Strap to your person, as  
the device will float to the surface if released.  
w
w
w
.
h
a
w
k
e
y
e
e
l
e
c
t
r
o
n
i
c
s
.
c
o
m
 
CARE AND MAINTENANCE  
Care for Your H22PX  
1. Clean the device with fresh water and dry off before storing.  
2. Remove the batteries from the device to prevent battery leakage and corrosion.  
3. Store the depth sounder in a cool, dry place. Never leave it in temperatures ovver  
158º F (70 ºC) as the extreme temperatures can damage the electronnic  
components.  
REPLACEMENT PARTS  
Individual components are not available for sale on our website. If you need replacemeent  
parts, please email our customer service department.  
The following Parts Are User Replaceable:  
Battery Cover  
Battery Holder  
Lanyard  
O-Ring Kit  
TROUBLESHOOTING AND FREQUENTLY ASKED QUESTIONS  
our online Knowledgebase for the latest troubleshooting and FAQ’s, or post your owwn  
question for our support staff.  
For one-on-one support please emaail  
INFORMATION:  
If you have questions about this  
device please visit our Customer  
Service Center on our website or call  
us toll free at 888-766-7276.  
Warranty Details Warranty Registration  
Troubleshooting Product Knowledgebase  
Product Specifications Parts & Accessories  
Nothing Happens When I Turn the Power On  
Make sure that you have installed a good set of batteries and aligned them as per thhe  
diagram within the battery compartment. You may also need to test the batteries in  
another device to ensure they are charged. If in doubt, replace the batteries with a sset  
from a newly opened package.  
The Depth Reading Is “---”  
Make sure that the sonar sensor is in direct contact with the water and that you are  
operating the unit in depths between 2.5 and 199 ft (.8 to 61 m). Be aware that the deppth  
signal is sent from the sonar sensor in a manner similar to that of flashlight beam. Holdinng  
the unit perpendicular to the water surface will ensure accurate readings. The unit will not  
w
w
w
.
h
a
w
k
e
y
e
e
l
e
c
t
r
o
n
i
c
s
.
c
o
m
 
function properly if there is air between the sonar sensor and the water surface; keep this  
in mind when using the device through a boat hull or ice.  
I See Fish Under the Sonar Sensor, but Nothing Appears on the Display  
As with the depth reading, the fish finder will not detect any objects that are closer than  
2.5 ft from the sonar sensor. If you’re fishing in water that is less than 3 feet deep, it is  
recommended to discontinue use of the fish finder.  
The Depth Reading is Incorrect  
Make sure that you are pointing the sonar sensor perpendicular to the water when trying  
to obtain depth readings.  
Extremely heavy vegetation may confuse the sonar of the fish finder causing it to  
misinterpret the depth. If you are certain that the readings are incorrect under these  
conditions, discontinue use.  
I’m Not Getting A Reading While Trying to Shoot Through My Boat Hull or Ice  
Shooting through the hull of a boat/canoe or ice can be difficult, as hidden air pockets will  
prevent you from obtaining a reading. Make certain that the hull or ice is solid from the  
surface to the water with no air bubbles and/or gaps. Shooting through composite hulls  
(plastic) or cloudy ice is not possible as tiny air bubbles are usually present in these  
situations.  
I’m Getting False Fish Indications  
The most common cause of false fish indications is extremely tall weed growth. If weeds  
grow taller than 50% of the total water depth in a particular area, the sonar will mistake it  
for fish. Trash & debris may also give false readings.  
ONLINE CUSTOMER SERVICE CENTER TOOLS  
w
w
w
.
h
a
w
k
e
y
e
e
l
e
c
t
r
o
n
i
c
s
.
c
o
m
 
WARRANTY  
This device is covered by a 2 Year Limited Warranty. To be eligible for warranty  
coverage, you must register your product within 15 days of purchase. Visit our website for  
warranty details and to register.  
To Activate Your Warranty:  
Read and print out a copy of the warranty details for your records.  
Complete the registration form on our website.  
Make a copy of your original purchase receipt and staple it to this manual. You will  
need to present it in the rare occurrence that you need to send your product in for  
service.  
Complete the information below and store this manual in a safe place. You can  
print additional copies of this manual from our website.  
INFORMATION:  
To aid in maintenance and service, record the following:  
Date of Purchase: ___________________  
Place of Purchase: _____________________________________  
Date of Online Warranty Registration: _____________________  
Production Date Code : ________ (3 digit code located on the device housing)  
LEGAL  
INFORMATION:  
Made in China. Tested to comply with FCC, CE & ROHS standards if  
applicable. Visit our website for compliance and warranty information. All  
Specifications and Prices Subject to Change Without Notice.  
NorCross Marine Products, Inc  
(P) 888-7NorCross (888-766-7276)  
(F) 407-370-6880  
(E) customerservice@norcrossmarine.com  
VER.04  
WARNING:  
© 2010 NorCross Marine Products Inc., All Rights Reserved. ALL  
unauthorized copying of the content of this document without the  
expressed written consent of NorCross Marine Products, Inc is strictly  
forbidden.  
w
w
w
.
h
a
w
k
e
y
e
e
l
e
c
t
r
o
n
i
c
s
.
c
o
m
 

Miele Vacuum Cleaner HS11 User Manual
MSi Computer Hardware G52 S9617X1 User Manual
Network Technologies Switch ST C5KVM 600 CE User Manual
Nexus 21 Marine GPS System DGPS User Manual
Niles Audio Speaker CM610 User Manual
Numark Industries CD Player CDN 32S User Manual
Optimus Home Theater System SYSTEM 728 User Manual
Oregon Scientific Laptop G068 User Manual
Oregon Scientific Radar Detector BAR206 User Manual
OWI Portable Speaker GR202 User Manual